Why is the body of a mobile wagon suddenly shaking?
If the mobile vending truck has a deviation or a slight degree of jitter during driving, it is generally caused by tires. The first possibility is that because the wheel balance of the mobile sales vehicle is not good, the driver needs to drive the vehicle to a professional repair station to make a balance and four-wheel alignment. If the mobile sales truck does not run away, it will only Sit down the balance of the tires on it.
The second situation is more serious. It may be due to the deformation of the tire steel wheel of the vehicle. The out-of-the-box condition is the need for professional inspection and repair at a professional repair shop. And this situation is usually locked in the mobile vending trucks which are older. If the new mobile sales truck is replacing tires and tires, it is necessary to balance the tires each time. Otherwise, when the weights are uneven, the steering wheel will appear to shake. When the body has appeared, The comfort of the vehicle and the sense of maneuverability will be affected when the camera shakes.
This can be caused by unbalanced deformation of the drive shaft of the mobile sales vehicle . This situation is mostly due to a collision before the mobile sales vehicle. The body shake that occurs when the vehicle is idling is also often encountered. If the mobile vending vehicle driver actually stops the vehicle and starts the vehicle, the body shake is more obvious when the engine is not turned off. Then you can consider whether it is because of the instability of the oil pressure, the deterioration of some components of the mobile vending engine, and so on.
If it is already fully cleaned up of the carbon vending engine's carbon deposit, the spark plug and the oil pad are replaced with new ones, and all the throttle valves have been cleaned, there will still be cases of idling mobile vending vehicle bodies. Then it is necessary to go to a professional repair station to check the fuel supply pressure of the fuel and whether the sensor at the time of intake is working properly. If the fuel supply pressure of the vehicle is abnormal and the value of the pressure sensor of the intake air is completely wrong. It will cause the vehicle to shake.
1, FY-16A Flat Face Mask Machine
Introduction:
Semi automatic flat mask production line adopts advanced design, only need to put the raw material on the feeding rack, after the completion of the modulating, the machine can realize automatic production. It only need one person to operate and fully realize the whole process of automatic production. The equipment also adopts ultrasonic welding, which is beautiful, sanitary, environmental friendly.The output is 150-200 pcs/min. The length of nose bridge bar can be adjusted. The product size error is ±1mm.
Features:
1. High efficiency(150-200 pcs per minute) but in small size. The whole machine made of aluminum alloy, make a fine and classic look and with good rust protection and sturdiness.
2.With high output and 1-4 layers of mask blank producing adjustable.
3.With nose pin inserting in line.
Specification:
Machine Size: L3340*W800*H2000mm without conveyor
L4840*W800*H2000mm with conveyor
Mask blank size: 175*95mm
Nose bridge is inside the mask.
Output: 150-200pcs/min
Voltage: 220V
Power: 3KW
Net Weight: 400 KG
Installation and adjusting:
Factory will adjust the machine to best working status before delivery. Factory offer adjusting and installing video to custom and offer on-line technical support due to the Virus affecting.
face mask machine, facial mask machine, face mask making machine, face mask
DongGuan FeiYang Packaging Machinery Equipment Co., Ltd , https://www.feiyang-machinery.com