Plasma cutting pressure instability solution

In recent years, we have seen the rapid development of science and technology in our great motherland. This made me feel extremely proud for me as a Chinese. With the advancement of technology and the progress of people, we will join the Chinese cutting machine trading network to make progress together. Join the hotline, we look forward to your call. Details:/
If the working pressure of the CNC plasma cutting machine is too high or too low, it will affect the cutting effect. If the working pressure is much lower than the specification pressure, it means that the discharge speed of the plasma arc is weakened and the input air flow is less than the specified value. At this time, high-energy, high-speed plasma arcs cannot be formed, resulting in poor cutting quality and imperfections. Incision of tumors. If the input air pressure is far more than 0.45 MPa, the working pressure is too large. After the ion arc is formed, excessive airflow will blow off the concentrated arc column, disperse the energy of the arc column, and weaken the cutting strength of the plasma arc.
Caused by the lack of work pressure are: air compressor input air is insufficient, CNC cutting machine air regulator valve pressure is too low, the solenoid valve has oil, gas path is not smooth and so on. On the other hand, if the air pressure is too high, the cause is mainly due to improper input air conditioning, excessively high pressure of the air filter regulator, or failure of the air filter regulator.
Solution: Before use, observe the output pressure of the air compressor. If it does not meet the requirements, adjust the pressure or overhaul the air compressor. If the input air pressure has reached the requirements, check whether the air filter pressure reducing valve adjustment is correct; the gauge pressure display can meet the cutting requirements. Otherwise, perform routine maintenance on the air filter regulator to ensure that the input air is dry and free of oil. If the input air quality is poor, it will cause oil pollution inside the pressure reducing valve, the valve core opening is difficult, and the valve port cannot be fully opened. In addition, torch nozzle air pressure is too low, you need to replace the pressure reducing valve; air passage cross-section smaller will cause the air pressure is too low, according to the instructions to replace the trachea.
[I can't think of it. I can't do it. Change your style from now on. Opening the Chinese cutting machine trading network is equivalent to opening up your wealth road, come and click on the website now! 】
Editor: zgqgjjyw

New Product Laser Cutting Machine C Series for metal tube

The Laser Pipe Cutting Machine have a wide processing range, and can be applicable to different kinds of material.

The laser generater is the BWT, the advantages are as below:

1.Fiber laser generator, using imported chips, with higher photoelectric conversion efficiency, lower power consumption
2.Deep research and development of core components: pump source, with 19 years of industry experience
3.High stability, low light decay, long service life
4.Its predecessor is the core supplier of most domestic laser manufacturers

laser cutting machine in Italy, laser cutting machine price, laser cutting metal pipe

GUANGDONG CHITTAK INTELLIGENT EQUIPMENT CO.,LTD , https://www.ctklasercutter.com