Moisture Analyzer Maintenance Notice

Laboratory Instrumentation Moisture Analyzer Maintenance and Maintenance I. Instrumentation Moisture Analyzer Installation and Location:

1. The instrument must not be installed in a room with corrosive gas. Corrosion of the circuit of the instrument will shorten the life of the instrument.

2. Where the room temperature is below 5 degrees or above 40 degrees.

3, can not be installed in places with high sunlight and humidity.

4. Do not install in places where the power supply is unstable. It is recommended to use an electronic voltage regulator.

Second, the electrode maintenance:

1. When the measuring electrode is contaminated, wipe it with acetone or absolute ethanol. If it still cannot be decontaminated, use an alcohol lamp to burn the platinum ball end.

2. When the electrolytic electrode is contaminated, acetone or anhydrous ethanol can be injected into the cathode chamber and shaken repeatedly to remove internal dirt.

Third, instrumentation moisture analyzer electrolytic cell drying:

The electrolytic cell was decomposed, placed in an oven at about 50 degrees for five hours, and allowed to cool after it was cooled.