Introduction to the installation method and method of LED display for weak current engineering
LED display products are currently used in many areas of the market, depending on the application area and installation environment, LED display installation methods are also different. Today, Liangcai will organize a set of the most complete LED display installation methods for everyone to learn. This time, we mainly introduce six common installation methods: hanging type, floor type, embedded, column type, support type, wall hanging type.
Figure:
1, hanging type
1) This installation method is mostly used indoors and semi-outdoor
2) Generally used for entrances of passages and corridors, as well as stations, railway stations, subway entrances, etc.
3) It is used for traffic induced use on roads, railways and highways.
4) The screen design generally adopts one-piece cabinet design or hoisting structure design.
2, mosaic installation
1) The entire LED display body is embedded in the wall, and the display plane is at the same level as the wall surface.
2) Generally adopt simple box design
3) General pre-maintenance (front maintenance design)
4) This installation method is used indoors and outdoors, but it is generally applied to a screen with a small pitch and a small display area.
5) Generally used for building entrances, building halls, etc.
3, column type (single column and double column)
There are a variety of column installation methods, generally used for outdoor billboards:
1) Single column installation method: suitable for small screen applications
2) Double column installation: suitable for large screen applications
3) Closed maintenance channel: suitable for simple cabinet
4) Open maintenance channel: suitable for standard cabinet
4, wall-mounted installation
1) This installation method is usually used indoors or semi-outdoor
2) The display area of ​​the screen is small, generally no maintenance access space is left, the whole screen is taken down for maintenance, or it is made into a folded integrated frame.
3) The screen area is slightly larger, generally adopting the front maintenance design (that is, the front maintenance design, usually adopting the column assembly method)
5, roof-mounted installation
1) This installation mode display and steel frame structure can resist wind power is a key
2) Generally installed with a tilt angle, or the module is designed with a slant 8°
3) mostly used for outdoor advertising display
6, rental lifting method
Precautions:
The lifting screen should not be made bigger. Generally required to be below 6M*10M. Exceptions to special cabinet materials and curtains.
The top is equipped with a lifting beam and the bottom is equipped with a bottom beam. The lifting beam is used to lift the screen.
Between the row and the row box, the hoisting mechanism is connected, and the horizontal box is fastened with a lock.
Lifting mechanism points: gear type, cone type, bolt type.
Has the following different characteristics:
1. The gear type is more expensive and beautiful.
2. The cone-shaped price is moderate and reliable.
3. The bolt type is cheap, reliable, and the assembly is troublesome, and it is suitable for the case of not being repeatedly disassembled.
In the actual engineering installation, there are some other installation methods, which are not introduced here. These six types are relatively common installation methods, and the installation difficulty is relatively small. The most important thing is to require the installer to install the operation process to strictly enforce, to ensure that the screen installation is qualified and safe. Only in this way can the LED display's communication effect be truly realized and meet the requirements of the advertiser.
Coatings And Paints,Anti Corrosion Pigments,Precipitated Silica For Paints Coatings,Precipitated Silica And Silicates
Henan Minmetals East New Materials CO. LTD. , https://www.east-silicones.com