Hydraulic gear pump requirements
1, the working fluid should be kept clean. It is recommended to install a filter with a filtration precision of 80 ~ 100μm on the oil suction pipe of the pump. The oil return pipe should be equipped with an oil filter with a filtration precision of not less than 25μm and periodically cleaned according to the oil pollution or replace.
2, hydraulic gear pump into the oil side if the filter, you should ensure that the effective filter oil flow rate should be greater than twice the maximum pump suction flow, and maintain smooth, to prevent blockage.
3, strict rules Before the start of the installation of the pump, you must grease the exhaust, so that the pump can turn on the oil in time to drive. It is best to release a pipe joint in the pressure pipe, move the power element to allow the oil to flow out until there is no bubble, and then tighten the pipe joint (this operation should pay special attention to press this treatment, the pump is not the initial operation Damaged the most encountered fault). After the installation of the pump should be no less than 10 minutes of no-load and short-time load operation.
4, gear pump in continuous operation under the maximum temperature shall not exceed 80 ℃, instantaneous operating temperature shall not exceed 120 ℃, so as to avoid premature seal aging.
More Keyword Search: Gear Pumps
A candle mold is a tool used to make candles that helps you make candles in a specific shape and size. Such molds can be of various shapes, such as hearts candle , stars candle, animal shapes candle , or simple basic shapes such as cylinders candle or rectangles candles.
When making candles, the inside of the mold is usually coated with a thin layer of grease or sprayed with a thin layer of powder to prevent the candle from being difficult to remove after it sets. The molten Soy Wax is then poured into the mold, and after the wax liquid cools and solidifies, the candle is formed. This mold is not only suitable for DIY candle making at home, but also often used for large-scale production in candle factories.
There are various types of candle molds on the market to choose from, including but not limited to Plastic candle molds, metal candle molds, silicone candle molds, etc. Different materials may have different advantages and disadvantages, such as silicone molds are easy to release but may not be durable, while metal molds may be more durable but need to be preheated before use. When choosing the right candle mold, you need to consider personal needs (such as shape, size, quantity) and budget factors
candle mold supplier,candle mold manufacture
China Senbo Industry Co.,ltd , https://www.yylpaper.com